H & S Model 235 Heavy Duty
Manure Spreader
$Call For Our "Below List Prices!"
H & S Design and Engineering guarantees longer equipment life.
Struck level 143 cu. Ft., 235 Bu. unloading speed for the 235 spreader - (2 speed gear box) high speed: PTO speed 540 RPM. 8'9" Per Minute - Low Speed: PTO Speed 540 RPM. 4'9" Per Minute.
The rear pan is standard on the 235.
The drive for the 235 spreader utilizes the patented H & S 2-speed gear box. Shifting is all done in the enclosed 2 speed/beater shutoff gear box. Note also the handy location of the main apron shear bolt and the sturdy hydraulic cylinder mount tube which extends all the way through the frame to the other side.
H & S spreaders have a massive unitized welded frame with heavy floor supports and side stakes, wrap around steel front corners. Strong rear main beater side panels are slanted for clearance and wider spread, and then welded to the strong 5" U channel side members. Compare with any on the market.
Front splash guards are standard equipment. The entire box inside, floor, sides of the rear hydraulic endgate use bonded polyethylene to marine type plywood to provide for easy cleaning and minimal freeze up. Condisderably less torque is needed to move a heavy load. The side flares are made of 10 gauge G210 culvert grade galvanized steel.
Model 235 can be equipped with the optional top beater to provide load leveling and spreading of high heaped loads. Notice how both beaters have no obstructions towards the sides and rear to provide for better spreading.
The 2-Speed apron drive is standard equipment. An optional variable speed hydraulic drive is also available.
An optional second hydraulic endgate cylinder is available for the model 235. The hydraulic lines are run through a 3 x 3 tube under the floor. The upright position of the hydraulic cylinder stroke allows the gate to lift with the least strain at pivot points. The extra side supports brace to assure years of service.
The model 235 spreader has a 29" diameter beater with 14 replaceable paddles. The beater has two types of paddles, blunt for widespread and sharp ripper type for cutting and shredding. The beater side wiper blades are standard.
The strong oil bath bevel gear box that powers the beater is tapered timken roller bearing equipped. Also shown is the replaceable splined hub that welds into the main beater tube. The gear box utilizes a 4-jaw beater shutoff clutch and tractor sized spline shaft.
Adjustment for the main apron is easy, by simply loosening the two side bolts and drawing up the long bolt.
H & S uses cast special steel alloy apron idler slides instead of idler sprockets making for years of dependable service.