H & S Model 370 Heavy Duty
Manure Spreader
$Call For Our "Below List Prices!"
H & S Design and Engineering guarantees longer equipment life.
Struck level 235 cu. Ft., 370 Bu. unloading speed for the 370 Spreader - (2 speed chain drive) high speed: PTO speed 540 RPM. 8'8-1/2" per min. - Low Speed: PTO Speed 540 RPM. 4'8-1/2" per min.
The rear pan is optional on the 370.
H & S spreaders have a massive unitized welded frame with heavy floor supports and side stakes, wrap around steel front corners. Strong rear main beater side panels are slanted for clearance and wider spread, and then welded to the strong 5" U channel side members. Compare with any on the market.
Front splash guards are standard equipment. The entire box inside, floor, sides of the rear hydraulic endgate use bonded polyethylene to marine type plywood to provide for easy cleaning and minimal freeze up. Condisderably less torque is needed to move a heavy load. The side flares are made of 10 gauge G210 culvert grade galvanized steel.
Model 370 can be equipped with the optional top beater to provide load leveling and spreading of high heaped loads. Notice how both beaters have no obstructions towards the sides and rear to provide for better spreading.
The 2-Speed apron drive is standard equipment. An optional variable speed hydraulic drive is also available.
A Semi-Liquid hydraulic endgate is standard equipment on the Model 370. A second hydraulic endgate cylinder is also standard.
The model 370 spreader has a 29" diameter beater with 14 replaceable paddles. The beater has two types of paddles, blunt for widespread and sharp ripper type for cutting and shredding. The beater side wiper blades are standard.
The strong oil bath bevel gear box that powers the beater is tapered timken roller bearing equipped. Also shown is the replaceable splined hub that welds into the main beater tube. The gear box utilizes a 4-jaw beater shutoff clutch and tractor sized spline shaft.
Gear box mechanisms and drive for the beater and apron are timken tapered roller bearing equipped. The beater drive gear box is 1-1 1/2 bevel gear oil bath equipped with a 4-jaw over running clutch for beater shutoff. The apron drive is a 50:1 bronze worm gear with shear bolt protection.
Adjustment for the main apron is easy, by simply loosening the two side bolts and drawing up the long bolt.
H & S uses cast special steel alloy apron idler slides instead of idler sprockets making for years of dependable service.