|
Above - The feed sensing option counts the impeller R.P.M. and recognizes when the skid loader is getting loaded up, due to a combination of large, long logs and not enough horsepower. If this happens the Feed Sensing will stop the feed roll and allow the skid loader to catch up.
|
The infeed opening on the 826 is 6” high x 12” wide. This extra wide opening accommodates brushy material and reduces the pruning and trimming.
|
|
The Chipper disc is 26” in diameter x 1” thick steel. It has 6 welded  and gusseted fan blades to exhaust chips, four reversible chip blades, each 1/2” thick x 4” wide x 5” long, and extra wide chip pockets to decrease clogging. The chipper disc is easily accessible for removal of chip blades, for replacement or for sharpening
|
Pictured is the backside of the impeller showing the extra wide chip blade pocket which increases chip exhaust thereby decreasing clogging.
|
| 826 SPECIFICATIONS |
| Paint |
Orange, polyester powder coat paint provides excellent outdoor weatherability and offers protection against ultra violet discoloration.
|
| Infeed Chute |
40” wide x 23” high, ( 920 sq. in.) 61” from edge to roll, 19 3/4” from ground to tray. Fold down infeed pan with sides. Control bar positioned at top of infeed tray to control movement of the feed wheel. High speed, low speed, neutral & reverse.
|
| Infeed Opening |
6” x 12” opening at the infeed roll. Less trimming and pruning.
|
| Chipper Disc |
1” thick x 26” diameter disc mounted on a 2” diameter steel shaft with six exhaust blades. Approximately 200 lbs.
|
| Chipper Blades |
Two sets of chip blades, 2 blades per set. Each blade is 5-3/32” long x 4” wide x 1/2” thick, oil hardened steel. Double sided.
|
| Bed Knives |
(2) One horizontal and one vertical. Both are adjustable, reversible and 1” thick steel.
|
| Feed Roll |
One 7” diameter x 12” long feed roll, with cutter blades, powered by a variable speed hydraulic pump.
|
| Hydraulic Tank |
8-1/4” x 10-3/8” x 10-1/4” steel tank. 4 gallon capacity, with lockable filler cap with dip stick.
|
| Hydraulics |
Sunstrand BDP10 piston type hydrostatic pump with variable speed control. Maximum feed rate, 94’ per minute. Hydraulic hoses - 2,500 lbs., P.S.I. working, 10,000 lbs. P.S.I. burst.
|
| Dimensions |
Length with feed tray closed - 65”
Width - 52”
Height to top of discharge - 84”
Weight - 1,560 lbs. (approx.)
|
