Valby SG36HD
Stone & Waste Grapple
This grapple has a two prong jaw on one side, and a single jaw on the other. The jaws and the wear parts are made out of Hardox steel.
Besides lifting stones, this grapple can also be used for the handling of logs. The form of the jaws is such that the grab also penetrates into piles of brush or logging slash. The wear plates and the sturdy jaws enable the grapple also be used in the handling of building debris. The design of the grapple makes it an all-around utility grapple.
The grapple opens to 36". To hold anything securely in the grapple, it must close at least 10".
The Valby SG36 HD stonegrapple has bypass jaws.
- Quality grapples have jaws that are made of Hardox steel, and have wear plates.
- Every joint in a Valby grapple has a grease fitting and a bronze bushing.
- The Valby grapples have powerful cylinders with heavy pistons.
- Twin connection rods provide good balance and less stress.
- A belly plate protects the cylinder from below.
- The Valby grapples are of modern bypass grapple design that support the log from underneath and both sides.
- The jaws close to a tight minimum opening.
- The SG36HD has a sturdy mounting plate. We recommend the R30 rotator.
- The Grapple is a bypass design, which enables controlled release of the load.
The grapple can handle logs up to 2 feet in diameter. With it's penetration capabilities,
this grapple can also be used to feed woodchippers and tub grinders.
The jaws of the SG36-HD grapple are formed to penetrate into brush piles.
The Valby construction debris grapple can be used for
handling blocks of concterte and other building debris.
The SG36-HD grapple opens up to 36".